Silentknight 5495 6A Distributed Power Module Manual de usuario descargar pdf (Pagina 34)

Model 5495 Distributed Power Module Installation Manual

30 151161

6.4 Removing and Replacing the Control Panel

This section provides instruction on how to remove and replace the control panel if it

is determined that the control panel needs to be repaired or replaced.

6.4.1 Removing the Control Panel

Follow these step to properly remove the control panel:

1. Remove the two heat sink screws. The heat sink screws are located on the top of

the cabinet. See Figure 6-1.

Figure 6-1 Mounting Screw Locations

2. Remove the four chassis mounting screws. See Figure 6-1 for chassis screw loca-

tions.

3. Carefully remove the control panel.

6.4.2 Replacing the Control Panel

Follow these steps to replace the control panel:

Note:Use a grounding strap when working with static sensitive components.

1. Align the control panel with the chassis mounting stand-offs. See Figure 6-1.

2. Insert the four chassis mounting screws (see Figure 6-1). Do not over tighten the

chassis mounting screws.

3. Insert the two heat sink screws (see Figure 6-1). Do not over tighten the heat sink

screws.

Note:The heat sink screws must be installed for proper heat dispersion of the power module’s power

supply.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Sin comentarios

Silentknight 5495 6A Distributed Power Module Manual de usuario Pagina 34